Inflatable Screen: 15M*10M
Material: Tarpaulin or Oxford
Thickness: 0.55mm

Installation instructions for inflatable movie screens
1. Spread a large piece of cloth on the ground;
2. Spread the screen unit on the cloth; Snap the rings on the edge of the screen onto the fasteners on the frame(picture 1)
3. Tie down the blower mouth into the air intake tube on the unit(picture 2)
4. Plug in the compaitable blower and start iflating; Product should erect on its own(picture 3)
5. Inflsted unit as in picture 4
6. Cautions
A. Try not to use product in rain; When in rain. Try to block part of the blower mouth with a piece of the zipper located near the inflation tube from time to release inside air pressure; This is done to prevent unit from being ripped open;
B. If soaked in the rain, product should be spread out and air dry before repackingand storing;
C. Blower must be protected from rain all the time;

7. When using a more powerful blower, refer to point A in 6
8. Fold product carefully after each use and store it in a dry place; Use desiccating agents(provided in the original packages) for a long period of storage;
9. Repari kit containing material cuttings are provided; When ripped, product can repaired by sewing logether with needle and thread.